Evo-Seal – 2L, 5L or 20L

EVO-SEAL – Penetrates up to 100mm.
Transparent, water based static/hydrostatic waterproof liquid impregnate tested to 4 bar (60psi).

Non toxic, non-caustic, non-flammable, inorganic polyester polymer formulation. Waterproofs, eliminates rising damp, insulates, hardens and preserves concrete, plaster, mortar and most natural stone permanently.

Causes a chemical reaction that solidifies the component parts of pre-cast block, masonry, concrete and cement mortars into a single mass making it waterproof, resistant to acid, oil, fuels, fats and grease. Will stop dusting, brick fretting, cracking, seepage as it increases the density of the substrate, increases wear capability. Prevents efflorescence.

• All old or new concrete, bricks, blocks, plastering/render and masonry construction.
• Concrete floors, walls, terrazzo and most natural stone. Above or below ground.
• Historical monuments, public buildings and new or old constructions affected by pollution.
• Roads, tunnels, decks, dams, subways, basements, swimming pools.

• Suitable over weak and old substrates.
• Prevents saponification of paints, does not contain oils or solvents. Prevents blistering.
• Safe for users and adjacent areas, it does not require special protection equipment.
• Non-corrosive, non-toxic and non-flammable.
• Environmentally friendly. Saves hazardous classified materials transportation cost.
• Problem free bond for paint, floor coverings.
• Will NOT harm glass, tiles or aluminium.
• Permanently waterproofs and preserves.

Apply EVO-SEAL by low-pressure spray operating at no more than 20 psi, back-pack or hand-spray ensuring a uniform and homogeneous coverage starting at the bottom and working across the surface and gradually working upwards. It is essential to saturate the substrate.
Allow EVO-SEAL to cure and penetrate for a period of about 12-24 hours.

Complete curing 4-5 days before painting or other application

See below for Technical Data Sheet and/or SDS Sheet

Download TDS

Download SDS